Mold Impression Guide

Please read every step before opening the putty. Each tray only has enough material for one attempt.

What’s Included

Your Kit

1 upper impression tray
1 lower impression tray
Blue and white impression putty

Only complete the impression needed for your order:

Top grillz: complete the upper impression
Bottom grillz: complete the lower impression
Top and bottom grillz: complete both impressions

Step 1

Get Ready

Brush your teeth thoroughly.
Wash and completely dry your hands before handling the putty.
Do not use the mold kit if you currently have braces.

Step 2

Mix the Putty

For each impression, use 1 full blue putty and 1 full white putty.

Mix both pieces together for approximately 45–60 seconds, until the putty becomes one even color with no white streaks. Once mixed, move quickly to the next step.

Step 3

Load the Tray

Roll the mixed putty into a thick, even shape and place it inside the tray. Place slightly more putty toward the front of the tray and above the tray walls. This helps capture your full teeth and most of the gum line.

Step 4

Make the Impression

Center the tray over your teeth. Using your fingers, press the tray firmly and evenly:

Press upward for the upper teeth
Press downward for the lower teeth

Do not bite down on the tray. Once the tray is fully pressed over your teeth, start your timer.

Step 5

Hold for 6 Minutes

Hold the tray firmly with your fingers for the entire 6 minutes, or until the mixed blue material is completely firm. Keep the tray as still as possible.

Do not:

Talk
Bite down
Shift the tray
Rock the tray
Remove it early

Step 6

Gently Remove the Tray

Once the putty is fully firm, gently remove the tray from your mouth. Do not yank, twist, rinse, wash, trim, or remove the putty from the tray.

Quality Check

Check Your Mold

A usable mold should show:

The complete shape of your teeth
Most of the gum line around the teeth
Clear, deep tooth details
No major holes, missing areas, or blurry sections

Approval

Upload Your Mold

Immediately after removing the tray, take one clear, straight-on photo looking directly into the finished mold. Keep the putty inside the tray.

Upload the photo through the STL Grillzz Mold Approval section on our website. If your order includes both top and bottom grillz, upload clear photos of both completed molds.

Do not mail your mold until STL Grillzz approves it.

Return

Returning Your Approved Mold

After approval:

Mail only the completed impression tray or trays
Include at least your order number inside the package
Return both trays together if you ordered top and bottom grillz
Use the return address printed inside your kit or displayed after approval

Return shipping is the customer’s responsibility. A prepaid return label is not included.

📷 Submit My Mold Photo